ARCTIC COOLING P14 Pwm Pst

Arctic Cooling P14 PWM PST

Pressure-optimised 140 mm Fan with PWM PST

Optimised for Static Pressure

During the development of the new P14 PWM PST, special emphasis was placed on a focused airstream and thus a high static pressure. The fan guarantees extremely efficient cooling, even with increased air resistance. Therefore, the P14 PWM PST is particularly suitable for use on heatsinks and radiators.

More Efficient Technology

The motor is powered by a Neodym-Iron-Boron-Magnet ring of the newest generation, which allows the new P14 PWM PST to run much more efficiently than its predecessors. This saves energy and lowers the coil temperature without comprimising the performance.

Power Consumption

1.44 W @ 1700 RPM

3.6 W @ 1350 RPM

Maximum Quietness, Minimum Vibration

Even at low speeds the operating sound of the new ARCTIC motor is barely noticeable.

Due to a sinus-magnetizing the new motor only creates about 5 % of the vibration from commutation of a regular DC-motor without filter. Consequently, there is no need for rubber spacers due to the steady and smooth torque of the new motor.

Fan with newly developed ARCTIC motor

Fan with regular motor and anti-vibration-rubber

Fan with regular motor without vibration absorption

Noise Level

5 % vibration from commutation

50 % vibration from commutation

100 % vibration from commutation

Extended Life Span

A 10 °C lower motor temperature roughly doubles the life span of a fan.

The new ARCTIC motor has a four times longer service life through its low coil temperature.

Consequently, we have extended the warranty to 10 years.

P14 PWM PST (New ARCTIC Motor)

With a wide range of regulation and the PWM Sharing Technology (PST), the P14 PWM PST fan speed can be controlled synchronously with all your other fans together. This keeps noise at a minimum while guaranteeing maximum cooling performance when needed.

High Quality Bearing

Thanks to an alloy/lubricant combination developed in Germany, friction within the bearing is reduced and greater efficiency is achieved. As a result, there is less heat development as well as less bearing noise, which means you can enjoy a longer service life from your fan.

Two Way Installation

Specifications  

Fan: 140 mm, 200 – 1.700 RPM (Controlled by PWM)

Air Flow: 72.8 CFM / 123.76 m³/h (@ 1.700 RPM)

Noise Level: 0.3 Sone (@ 1.700 RPM)

Static Pressure: 2.4 mm H2O (@ 1.700 RPM)

Typical Voltage: + 12 V DC

Start-up Voltage: 3.9 V DC

Cable Length: 400 mm

Sub PST Cable Length: 50 mm

Motherboard: + 12 V DC

PWM control signal: 4-pin connector + 4-pin socket