AVAYA Interface Cards/Adapter

PRI Trunk Cards

This card can be added to an IP500 base card to provide that card with support for PRI trunks. The card is available in single port or dual port variants.

This card can be fitted to any IP500 base card except the IP500 Legacy Carrier card and IP500 4-Port Expansion card.
· Ports/Channels
1 or 2 PRI trunk ports . Each port supports the following PRI line types. On dual port cards, both ports will be the same line type. The line type selection can be changed using IP Office Manager. The options available depend on the IP Office operation mode and locale.
· E1 PRI (30B+D channels per port).
· E1R2 PRI (30B channels per port).
· T1 robbed bit (24B channels per port) or T1 PRI (23B+D channels per port).
· The required mode can be selected within IP Office Manager by rightclicking on the line icon and selecting Change Universal PRI Card
Line Type and then selecting the required line type.
· Physical trunk connection is via ports 9 and 10 of the host IP500 base card.
· Port 11 and 12 can be used as test points for connection of test and monitoring equipment for the adjacent port.
· Licenses
The IP Office system supports 8 unlicensed B-channels on each IP500 PRI-U port fitted. Additional B-channels, up to the capacity of ports installed and PRI mode selected require IP500 Universal PRI (Additional Channels) licenses added to the configuration. These additional channels consume the licenses based on which additional channels are configured as in-service from port 9 of slot 1 upwards. D-channels are not affected by licensing.
· Maximum per Control Unit: 4 per control unit in IP Office Standard Version mode. 1 single port card only in other modes.
· Software Level: 4.1+.

IP Office 500 Trunk Card Primary Rate 1 Universal 700417439
IP Office 500 Trunk Card Primary Rate 2 Universal 700417462