| DSP |
| DSP |
2 x 32/64bit |
| Sampling Rate |
48kHz |
| Latency IN to OUT |
<2.9ms (+1ms for 16x16) |
| Converters |
| Resolution |
24bit AKM |
| Dynamic Range |
AD:110dB, DA: 115dB |
| Analog |
| 8+8 Input/Output |
Terminal block (Symmetrical) |
| 2 monitor output |
Terminal block (Symmetrical) |
| Headphones related |
Jack ¼ |
| Analog Input headroom |
+27dBV = +30dBu |
| Max. output level |
+18dBV = +21dBu |
| Input sensitivity @ 0dBV out |
From -50dBV to +10dBV in 0.5dB step |
| Input Impedance |
Balanced, >4kΩ |
| Phantom power |
+42VDC, 5mA max. software switched |
| Headphones |
>200mW/200Ω |
| Frequency response (-3dB) |
5Hz to 24kHz |
| Flatness |
better than ±0.1dB |
| THD+Noise @ 1kHz, 0dBV input (line) |
<0.004% |
| THD+Noise @ 1kHz, -40dBV input (mic.) |
<0.008% |
| Output Noise floor FFT (20Hz - 20kHz) |
better than 115dB |
| Interchannel crosstalk (20Hz - 20kHz) |
better than 90dB (100dB typ.) |
| Channel Leakage (20Hz - 20kHz) |
better than 100dB (115dB typ.) |
| CMRR 20Hz- 20kHz |
65dB typ. |
| Processing |
| Input Level (x8) |
Range: from Off to 0 dB |
| Mute: Yes |
| Signal Polarity reverse: Yes |
| Metering: VU+clip pre & post fader |
| Output Level (x8) |
Range: from Off to 0 dB |
| Mute: Yes |
| Solo: Yes |
| Signal Polarity reverse: Yes |
| Metering: VU+clip pre & post fader |
| Input Delay (x8) |
from 0 to 1000 ms |
| Units: sec/ms/m/cm. |
| Output Delay (x8) |
from 0 to 1000 ms |
| Units: sec/ms/m/cm. |
Parametric Eq. Types
(4 max per input)
(8 max per output in 8x8 mode)
(4 max per output in 16x16 mode) |
Bypass / On-Off all channels |
Param Eq. Freq: 20Hz-20kHz
Gain: -60/+12 dB
Q: 0.3 to 200
|
| Low & High Shelf 6/12 dB/oct |
| Low & High Pass 6/12 dB/oct |
| All Pass 1/2 order |
| High & Low pass output Crossover filters (x8) |
Bypass On-Off |
| Butterworth in 6/12/18/24 dB/oct |
| Bessel in 12/18/24 dB/oct |
| Linkwitz-Riley in 12/24 dB/oct |
| Input Noise Gate (x8) |
Bypass On-Off |
| Threshold: from –80 dBV to +18 dBV |
| Depth: 0 dB to 80 dB |
| Knee: hard / soft |
| Attack time: from 0,1 ms. to 500 ms. |
| Hold time: from 10 ms. to 3000 ms. |
| Release time: from 10 ms. to 1000 ms. |
| Input Compressor / Limiter (x8) |
Bypass On-Off |
| Threshold: from –36 dBV to +18 dBV |
| Ratio: 1:1 to inf:1 (limiter) |
| Knee: hard / soft |
| Attack time: from 0,1 ms. to 500 ms. |
| Release time: from 10 ms. to 1000 ms. |
| Make up gain: from 0 to +10 dB |
| Output Limiter (x8) |
Bypass On-Off |
| Threshold: from –36 dBV to +18 dBV |
| Ratio: inf:1 (limiter) |
| Attack time: from 0,1 ms. to 500 ms. |
| Release time: from 10 ms. to 1000 ms. |
| Built in Signal Generator |
Sine: from 20 Hz to 20 kHz |
| Polarity: from 20 Hz to 20 kHz |
| White noise |
| Pink noise |
| Stereo Linking |
Adjacent input / output channels |
| Linked processing |
| Matrix routing linked |
| Mix Matrix |
Size: 8x8 (1-MIMO88) |
| Size: 16x16 (2-MIMO88 with expan. link bus) |
| Vol: Input, Output, Crosspoint |
| Mute: Set/Clear individual, row, column, all |
| Input /output Mono/stereo selector |
| Meter: Input /output VU and clip |
| Pager (x2) |
Input: IN1 to IN8 (or to IN16 in 16x16) |
| Priorities: 1(max) 2 (min) |
| Depth: 0 dB to 80 dB |
| Attack time: from 0,1 ms. to 500 ms. |
| Release time: from 10 ms. to 1000 ms. |
| Chime Source: None, Melody 1, Melody 2 |
| Chime Volume: from –12 dB to 0 dB |
| Mechanical |
| Dimensions |
482.6x44x266.5mm |
| Weight |
3.5kg |
| Supply |
| Mains |
90-264VCA 47-63Hz |
| Power consumption |
75VA |
| Miscellaneous |
| Management Connectivity |
Ethernet Base-Tx 10/100Mb Auto X-Over CAT5 up to 100m. |
| Expansion LINK BUS (16x16 ch.) |
Proprietary over CAT5, Xover cable up to 100m. |
| Remote Bus |
2, over twisted pairs; up to 1km (see specific specs.) |
| GPI |
8, from 0 to 10VDC or TTL level |
| GPO |
8, 3 poles isolated relay; 1A, 48VDC max. |
| Aux. Power Supply for Remotes & GPI |
+12VDC, 1.2A. max. (short circuit protected) |
| Time and date retention (battery) |
1 month aprox. (ambient temperature dependant) |
| RTC accuracy |
±1 minute /year |
| SOFTWARE |
| EclerNet Software |
Realtime full GUI of all functions and controls thru Ethernet with interactive graphical display |
| Grouping mode channels or devices |
| Grouping of other groups |
| Automated report generation |
| Up to 256 devices on same net |
| Autodiscovery devices feature |
| Routing capability through NAT gateways |
| Real time metering at input/output (DSP) |
| Device “Finder” feature |
| Save & Recall setup and preset functions |
| Firmware update capability thru Ethernet |
| Password protection (device & project with two user levels) |
Default Network configuration:
IP: 192.168.0.100
Mask: 255.255.255.0
Gate: 192.168.0.1
UDP Port: 2210 |
| Operating System |
Windows® W2000 Prof. (SP4); XP Prof. (SP3); Vista (SP1), W7 |
| Minimum EclerNet System Requirements |
Pentium IV ® 1GHz |
| 512MB RAM |
| 40MB HDD free space |
| 800x600 pixels & 16bits color display |
| 10/100/1G Ethernet Network card |